3Com (R) Corporation EtherDisk (R) Diskette for The EtherLink 10 ISA NIC Family Clarkson Packet Driver The EtherLink 10 ISA family of NICs are all software configured. When the packet driver is loaded the only required command line parameter is the software interrupt value `PKT_INT_NUM.' This software interrupt is used for communication between the driver and the protocol and should not be confused with the NIC's hardware interrupt. As of version 1.09 of the Packet Driver Specification valid software interrupt values are in the range 0x60 to 0x80. The packet driver for the EtherLink 10 ISA is a DOS mode driver that does not support plug and play. Plug and play must be disabled on the EtherLink 10 ISA, and this can be done by running PNPDSABL.BAT from the second diskette of the 6.1 driver set. The packet driver for the EtherLink 10 ISA does not support auto-media sensing. The driver will default to the media programmed on the NIC. The default is "Twisted Pair" when the adapter is shipped. The NIC can be forced to the appropriate media by running the configuration utility, 3C5X9CFG.EXE, from the second diskette. Refer to the manual for instructions on configuring the 3C509B NIC. The SLOT and IOBASE parameters are to be used only when there is more than one EtherLink 10 ISA board in the machine. This parameter indicates to the packet driver which NIC to use. For NICs in ISA mode, use the IOBASE parameter. On Microchannel NICs, EISA NICs, or ISA NICs in EISA mode, use the SLOT parameter. You cannot use both IOBASE and SLOT on the same command line. EXAMPLE: You have two EtherLink 10 ISA NICs in your machine. One is installed at I/O Base 300 hex and the other at 320 hex. To use the card located at 300 hex and load it at software interrupt 60 hex for use in a Windows environment, use the command line: 3C5X9PD -w 0x60 IOBASE=0x300 For a complete usage summary, enter 3C5X9PD at the DOS command prompt. (%VER PACKET.TXT - Packet Driver v6.1b)