DEC VNswitch 900 100baseT PCB

EK-MBITM-IM 100 Mb/s Fast Ethernet Modular Media Interface Cards Installation

NOTE: There are NO component IDs on the board. If you disagree with my arbitrary naming, by all means, share the documentation that you are using! Tell ME!

Fast Ethernet Port Subsystem

The Fast Ethernet port subsystem, shown in Figure 3-3, includes two SEEQ 10/100 EtherMACs tied to external FIFOs and controlled by a Xilinix FPGA and PALS. Each SEEQ MAC attaches to an MMI connector through its MII interface. The MMI connector supports a set of modules that provide fiber and UTP connections.

VNswitch Fast Ethernet 100base T Board, Top 54-24839 / 1R70503523 (L1)

IDT 723641
Port A
Port B
RISER 1
RISER 2
XILINIX XC4005C
Y1 27.0000 MHz osc
0

IDT 723641L20PQF CMOS SyncFIFO 1,024 x 36 datasheet
VNswitch Fast Ethernet 100base T Board, Bottom 54-24839 / 1R70503523 (L1)

EPROM ?
Grounding Fingers
 SEEQ QQ80C330 Hurricane
0

 SEEQ QQ80C330 FDX CMOS Ethernet 10/100 Mb/Sec Data Link Controller datasheet

DEXYU-AA 100baseTX MMI 54-24841 (L1) / 1R74612300

HALO TG 2-3209 HIPOTTED
83223 Network Transceiver
83840 Ethernet PhyLayer
 LED
P1 RJ45
QS3257 MUX/DEMUX

Not totally sure on the HALO matching transformer, the sticker peeled up most of the lettering, and I had to try reading the lettering backwards. Sorry...

83223 DP83223 TWISTER High Speed Networking Transceiver Device datasheet
 83840 DP83840A 10/100 Mb/s Ethernet Physical Layer datasheet
QS3257 Quickswitch High-Speed CMOS Quad 2:1 MUX/DEMUX datasheet


9595 Main Page