*********************************************************************
*********************************************************************
**                                                                 **
**                    Hardware Update Procedure                    **
**                                                                 **
*********************************************************************
*********************************************************************


*** WARNING *** The driver must be upgraded prior to upgrading the 
hardware.  Should you not upgrade the driver first, the system may 
not boot properly.

The 3ware on-board code-set requires a DOS bootable diskette to boot the 
system and run the installation program.  This utility DOES NOT work in 
a Windows DOS box.

1. Make sure you have the correct code-set for your board.
   To identify whether your board is a 3w-6x00 board or a 3w-7x00,
   open 3DM HTML and go to the Detail page.
2. Update the driver first if you haven't already done so.  Once the driver 
   installed/updated successfully, insert a DOS bootable 
   diskette version 6.22 or later into the floppy drive and boot the 
   system to DOS.
4. Insert the diskette containing the hardware upgrade code into the drive.
5. Type "upgrade.bat" at the A: prompt then press enter.  Follow the 
   instructions on the screen to update the code-set.
6. If the code-set you download is incompatible with your board, the code-set
   will not upgrade and an error message will be reported.
7. Once the upgrade is successfully completed, turn off the system as instructed.
   Remove the floppy diskette from the drive. Next, turn your system back on 
   to execute new code-set.
8. If you have upgraded your driver and your hardware correctly, the system
   will boot and work correctly.
9. If your system doesn't boot and your OS is installed on our controller,
   you will have to go into your system BIOS to change the boot order.
   Follow your system guide if you don't know how to perform the operation.
   Consult the BIOS Settings section in the manual that accompanied the 
   system and/or motherboard.

*** Multiple Boards System ****
1.  If your system contains multiple 3ware controllers, the upgrade utility
    will display all the boards on your system and ask you to choose the
    board you want to upgrade.  You can only upgrade one board at a time. To 
    upgrade multiple boards, you have to re-run the 
    utility program and choose a different board each time until all boards are updated.
2.  If you are upgrading 6000 series boards you may only have a maximum of 3 boards in 
    the system at at a time due to system resource issues. If there are more than 3 
    boards in the system the upgrade utility will fail due to insufficient system memory.

For questions, please visit our website at www.3ware.com or call us
at 877-88-3ware (877-883-9273) or +01-650-614-3439.

710-0046-01 Rev A