Sun PC-NFS

The NIC2000 NDIS 2.01 driver can also be used with the Sun PC-NFS (version 5.x)
environment.


Follow the steps listed below:

1       Be sure PC-NFS is installed on your system and configured for an NDIS
        2.01 driver. See the PC-NFS Installation Procedure Manuals for more
        information.

2       Run "NFSCONF". Select "Adapter" Menu. Select "Ethernet". Select "NDIS".

3       Insert the PC-NFS QUIKNDIS diskette into the floppy drive. Change to
        the drive containing the QUIKNDIS diskette (e.g., "A:\").

4       At the prompt type:

                QUIKNDIS

        Then press <Enter>.

5       A message will appear asking for the current boot drive. Enter the
        current boot drive and then press <Enter>.

6       Press "Y" to save the current "PROTOCOL.INI" file as "PROTOCOL.OLD".
        Ignore this step if this dialog box does not appear.

7       In the "Adapter Card List" box, select the "Custom" option to install
        the NIC2000 NDIS driver for PC-NFS.

8       Remove the QUIKNDIS disk from the floppy drive. Insert the NIC2000
        NDIS 2.01 driver diskette into the floppy drive.

9       Follow the dialog boxes and enter the correct driver and path on the
        NIC2000 NDIS 2.01 driver diskette to install the NDIS driver (e.g.,
        "A:\mslanman.dos\drivers\ethernet\nic2000\").

10      Enter "PCNTND" for the NIF file name and then press <Enter>.

11      Make the appropriate changes to "CONFIG.SYS" and "AUTOEXEC.BAT".

12      Reboot your system.

        The installation of the NDIS 2.01 driver for PC-NFS is now complete.