Triones
             Bus Master EIDE/ATAPI Device Drivers for Intel PIIX
                               WINDOWS 95

                             Revision 3.70B
                           (December 12,1997)

#############################################################################

NOTE: 
    This Windows 95 driver dose not support CD-ROM Changers. If you have a
    ATAPI CD-ROM Changer installed in your system, please do not install
    this driver!

1   INSTALLATION
    1.  Insert the floppy disk into drive A:.
    2.  Open "My Computer", double click "Drive A:".
    3.  Double click "Win95".
    4.  Double click the Setup program.
    5.  Then just follow the instructions to install the driver.

    IMPORTANT NOTE:
    We have found that the Windows 95 OSR2 version would fail to load the
    driver on some systems using PIIX4(TX) chipset after you install and
    restart the system. The following step could solve this problem if it
    happens:
    1.  Go to <MyComputer and double click Control Panel>
    2.  Double click System then go to Device Manger and View Devices by Type
    3.  Go to hard disk controllers
    4.  Double click Intel PIIX4 Bus Master IDE Controller (Ultra DMA supported)
        (there should be a yellow mark besides this instance)
    5.  Click Resources and you should see a box near the bottom of the screen
        that says Set Configuration manaully.
    6.  Click on the Set Configuration manually and you will see a check next
        to Use automatic setting
    7.  Uncheck the box and when the system asks you to reboot click yes
    8.  After the system restarts the yellow mark should be gone and your
        display in the Device Manger should look like this:
        Intel PIIX4 Bus Master IDE Controller (Ultra DMA supported)
        Primary IDE Contoller
        Secondary IDE Controller
    
2   DE-INSTALLATION
    1.  Insert the floppy disk into drive A:.
    2.  Open "My Computer", double click "Drive A:".
    3.  Double click "Win95".
    4.  Double click the Setup program.
    5.  Then just follow the instruction to de-install the driver.