----------------------------------------------------------------
           Network Everywhere FAST ETHERNET ADAPTERS SOFTWARE DRIVERS
           Copyright 1995-1999 Network Everywhere, All rights reserved.   
        ----------------------------------------------------------------
           

How to Config Your PCI adapter.
-------------------------------
 1. Firstly , you must find the PCI configuration item in BIOS setup.

 2. There are some key points you must take care of.

   a).  You should know what slot your adapter plug in. You can find the
        slot number in your mother board or its operating menu.

   b).  Enable this device.

   c).  Enable "master" this item.
        The Network Everywhere Fast Ethernet Adapter MUST be installed
        in a bus master PCI slot.  Refer to your system documentation to
        determine which slots support bus mastering.

   d).  You can choose what interrupt line you used in some BIOS setup.
        For this adapter, you must choice "INT A" in this item.

   e).  Choose what interrupt number you want. You can assign it in what
        interrupt you choose or in the slot number you choose.

 3. When you finish your configuration. You can run the diagnostic program
        in the driver diskette. If any problem, please contact your dealer.

NOTICE !!

        Conflict with Microsoft EMM386
        ------------------------------

        Problem:
        If there is any version of EMM386 prior to version 4.49 on
        DOS system, when users run the drivers for a 32-bit I/O 
        read/write which will cause the system to be hang and/or reset.

        Fix:
        Use version 4.49 or higher releases of the EMM386 memory manager(
        available with MS-DOS version 6.22).
        End-users with earlier version of the EMM386 memory manager should
        contact their OEM or Microsoft for information on obtaining an
        updated EMM386 device driver.