Driver Compatibility


      Our Plug&Play ethernet adapter supports AUTO, jumperless/PnP and
      jumper modes. You can set the adapter's mode to jumper mode or to
      AUTO/jumperless/PnP mode by the jumper on the card. The default mode
      is AUTO mode for ver 3.x or PnP mode for ver 2.x. You can set
      the adapter's mode to AUTO, jumperless or PnP by running setup.exe
      program provided in this driver diskette.

      For ver 3.x adapters, it is recommended to use AUTO mode always. The
      adapter will set to the appropriate mode according to your sytem,
      regardless the system is PnP or non-PnP system.

      For ver 2.x adapters, it is recommended to use PnP mode if your PC
      supports PnP feature, or it is recommended to use jumperless mode
      if the PC does not support PnP feature.

      Our Plug&Play ethernet adapter supports turbo function to speed up
      packet receiving and transmission. We provide some popular drivers
      with turbo feature in this driver diskette.  Our drivers improve
      the performance of the network adapter about 30%. It is strongly
      recommended to use the driver in this diskette for our Plug&Play
      adapters instead of any other NE2000 compatible drivers.

      Our Plug&Play ethernet adapters are software compatible to NE2000+,
      NE2000 and NE1000. If you need a driver we do not support by now,
      you can use any compatible drivers in your hand. You must set the
      operating mode of PnP ethernet to jumper or jumperless mode and
      setup the ethernet's configuration first, and then follow the setup
      procedure of your driver to install your driver to your target system.