Windows NT 3.5

   Introduction:
   -------------
   This document describes the procedure to install  Windows NT v3.5
   driver for ISA Plug&Play  ethernet adapter.

   Location of Driver:     \WINNT40\PNPWNT.SYS

   Installing driver procedure on Microsoft Windows NT :
   -----------------------------------------------------
   1.  Start Windows NT.

   2.  Double-click the Main group icon.

   3.  Double-click the Control Panel.

   4.  Double-click the Network icon.
       The Network Settings window appears.

   5.  Click the Add Adapter button.
       The Add Network Adapter window appears.

   6.  Select the "<Other> Requires disk from manufacturer" option then click
       the Continue button.

   7.  Insert the Driver Diskette into the floppy drive.

   8.  At the Insert Disk window type:
          A:\WINNT40

   9.  Click the OK button.
       The Select OEM Option window appears.

   10. Select the ISA Plug & Play Ethernet Adapter

   11. Click the OK button.
       A screen appears with "Input Ethernet ID" dialog box. This option
       is only required when you have more than one EtherPaC ISA LAN
       adapters in this computer.

   12. Select Skip, if only one adapter is installed in this computer.
       Windows NT will perform the binding process. If any additional network
       software options were installed, you may be prompted for specific
       information for these packages.

   13. Select the ISA bus type and click the OK button.

   14. Complete the installation by following instructions provided by 
       Windows NT.

   15. Restart the computer.

   NOTES:
   ------
      *  Installing Multiple LAN Adapters:

         Start Windows NT and follow above setup procedure. In the
         "Network Settings" dialog box, choose the "Configure.." button.
         The "Input Ethernet ID" dialog box appears and enter the
         adapter's Ethernet ID. Select OK and close Network setup.

         Select SKIP if only one adapter is installed in this computer.