3810 HD  (250-3571)          Power Utilities            Faxback Doc. # 1514

You can change several of the computer's power parameters by running the
Power program (Power381). The Power program temporarily overrides the Setup
program's power-management parameters.

The Power381 Utility lets you:

* Enable and disable the power management
* Enable and disable the serial ports
* Set the hard disk timeout
* Set the display timeout
* Set the standby mode timeout
* Set the resume mode timeout

To run the Power381 Utility, follow these steps:

1. Exit from the program you are currently in.
2. If you are not in Drive C, type:  c: <ENTER>
3. Select the DOS directory by typing:  cd \dos <ENTER>
4. At the prompt, type: Power381 <ENTER>

The Power program screen appears.

Use the up and down arrows to select the parameter you want to change.
Then, press the left and right arrows to select the setting for the
parameter.

5. Press F1 to save your changes. If you do not want to save the changes,
   press ESC.

Notes:

* The changes you make using the Power program are immediately active.
* The changes you make using the Power program are lost when you turn off
  your computer. When you turn on your computer again, it returns to the
  Setup parameters. However, if the Resume mode is active, the computer
  retains the Power program settings (except hard disk timeout) until you
  reboot or reset the computer.


(jej-05/10/94)