1500 HD (250-3506) Using the Setup Utility Faxback Doc. # 1904 Machine Startup: INITIAL START-UP PROGRAM DESKMATE MEMORY DIAGNOSTICS ON START-UP NO SERIAL PORT ASSIGNMENT PRIMARY:MODEM, SECONDARY:RS-232C BEEPER ENABLE CURSOR TYPE LINE Power Management: AUTOMATIC FLOPPY DISK STANDBY ENABLE DISPLAY TIMEOUT INTERVAL 1 MINUTE LOW POWER BEEPER ENABLE HARD DISK TIMEOUT INTERVAL 2 MINUTES ESC TO QUIT F1 TO UPDATE F10: FACTORY SETTINGS Changing the Computer's Functions: Setup: The SETUP program lets you select START-UP and POWER-MANAGEMENT parameters, and store the parameters selected in memory. The computer uses these parameters each time it is started up, unless they are changed using SETUP. When the SETUP program is used, the computer must be turned off or press to initialize the new parameters. Startup Parameters: The Startup parameters allow you to select internal programs to automatically run when the computer is turned on. The Startup parameters allow you to: * Turn on and off memory diagnostics * Change the serial port assignment * Select the initial start up program * Select the cursor type * Enable the speaker To Run the Setup Program in DOS: 1. Exit from DeskMate (or any other program) 2. If you are not in Drive C, type: C: 3. Select the DOS directory by typing: cd dos 4. At the MS-DOS prompt, type: setup_15 The Setup program screen appears. 5. Use the up and down arrows to select the parameter you want and press the right and left arrow keys to choose the setting. 6. Press if you want to save the changes. If you do want to save the changes, press . If you want to restore all parameters to the factory settings, press . Note: You must reset your computer by pressing , or by turning off the power and restarting, for the changes to take effect. (jej-05/10/94)