Hard Disk Controller Board  (250-1007)      Cables     Faxback Doc. # 2024

ATTACHING AND ROUTING CABLES
1. There are three cables provided, on wider that the other
   two. All the cables have a short wire, ending in a plastic coated push-on
   connector, extending from one end. If you are connecting only Drive C, you
   will need only one of the narrow cables. The second narrow cable will be
   used should you obtain a Drive D. The edge connector at the end of the
   cable with the short wire should be inserted only one way. Route the
   cables towards the right-hand edge of the board.
2. Remove the two self-tapping screws from the strain-relief clamp. Then
   remove the clamping plate from the bracket. Put the clamp and screws aside
   for the moment.
3. Dress both cables across the board and over the strain-relief bracket.
   Replace the clamp plate and affix the plate with the two sheet metal
   screws. Do not over tighten the screws.

(css/jej-05/11/94)