Memory Expansion Board  (250-5030)    Installation      Faxback Doc. # 2038

The following are instructions for installing the 32-Bit Memory Expansion Board 
in your computer. If you have any doubt about installing the board in your 
computer, have the service technician at your local Radio Shack Service 
Center install it for you. Doing so ensures expert installation but also 
enables the technician to quickly check to be sure the equipment is 
functioning properly. If you decide to install the board yourself, be sure to 
follow the instructions carefully.

1. DO NOT stand on a carpeted floor during the installation. Discharge any 
   built-up static electricity by touching a grounded metal object. Before 
   continuing, you must run the SETUP program on the Utilities disk following 
   the instructions in your Installation and Operation Manual. Doing so 
   identifies the added memory to your system configuration.

2. Be sure to turn off all equipment. If you have not done so, turn off the 
   computer, and disconnect the power cord from the system unit.

3. Remove the computer's cover as described in the "Video Card and Monitor 
   Installation" section of your computer's Installation and Operation Manual.

4. Remove the screw holding the slot cover for the special slot marked 32-Bit 
   Memory, and remove its slot cover.

5. Plug the board into the special socket provided on the main logic board. It 
   is marked 32-Bit Memory.

6. Put the board back in with the screws you previously used to hold the slot 
   cover.

7. Store the slot cover for future use.

8. Replace the computer cover as described in the "Video Card and Monitor 
   Installation" section of your computer's Installation and Operation Manual.

9. Reconnect your power cord, and turn the equipment back on.

(RJS/jlc-03/28/94)