Enhanced Graphics Adapter  (250-4037)   Installation    Faxback Doc. # 2126

The Enhanced Graphics Adapter is designed to work with the Tandy 1200 HD,
Tandy 3000, Tandy 3000 HL and compatibles. The instructions for removing the
cover and setting the motherboard switches and/or jumpers for these three
computers are given below. If you are installing the Enhanced Graphics Adapter
into a compatible computer, refer to your computer's Operations manual for instructions on removing the cover and setting motherboard switches
and/or jumpers.

Installation:

1. Locate the slot in which you want to install the Enhanced Graphics Adapter. 
   Remove and save the retaining screw holding the small metal cover plate.

2. Remove and save the cover plate. If, at a later time, you take the Enhanced 
   Graphics Adapter out of your computer, replace the cover plate.

3. Slide the Enhanced Graphics Adapter into the card guide slot and carefully 
   plug the board into the bottom connection. Be sure the gold "fingers on the 
   bottom of the Enhanced Graphics Adapter are firmly and evenly seated into 
   the connector on the motherboard.

4. Replace the retaining screw.

5. Double check you work. Replace the main unit's cover. Tighten screws. Plug 
   in the computer and all peripherals. Insert a diskette. Turn unit ON.

SYSTEM CHECKOUT

Once your Enhanced Graphics Adapter is installed and the PC is powered up, 
your computer will automatically check itself. If you are installing the 
Enhanced Graphics Adapter into a Tandy 3000 or Tandy 3000 HL computer, you 
must run the Setup program. The Setup program is located on the system 
utilities diskette located in the back of your computer's Installation and 
Operations Manual.