40 MB Smartdrive (250-1046) Re-Install Instructions Faxback Doc. # 3060 The following is the RE-INSTALL instructions for a 25-1046 when booted from the INSTALL BACKUP diskette. Boot machine with dos disk At prompt, type C:INSTALL Hard Disk Installation Program Version 8.1 for 40 SmartDrive Cat No. 25-1046 Copyright (C) 1985-1989 Western Digital Corporation You will need a blank diskette to continue this program. This program is going to install your hard disk for you. Most of the operations are automatic; however, the install program will beep if it needs you to do something. Press any key to continue... Because of its capacity, your hard disk will be split into two volumes. How would you like your hard disk to be split? 1) Equal sizes (approx. 20 meg each) 2) First drive of 30 meg, second of 10 meg. Select 1 or 2 ? ___ Initializing and Testing hard drive... There will be no screen activity for the next few minutes while the best performance Interleave is measured. (pause) The best interleave is 4 There will be no screen activity for about the next 5 minutes while the hard drive is formatted. (5 min pause) Do you want to restrict cylinders from use? (Y/N):__(answer N for no) (answer yes if you need to restrict additional cylinders than the ones listed above restricted from use) Scanning disk surface... Low level format complete Computer REBOOTS automatically Formatting hard drive... takes 3 to 15 minutes, but varies from system to system. 00:00 (elapsed time) Installation or your hard drive is complete! Remove the backup diskette. Store your installation backup diskette(s) in a safe place. If you ever need to re-install your hard drive, boot your system from the diskette labeled INSTALL BACKUP. Press any key to reboot your system from the hard drive... (dkh-08/06/93)