40 MB Smartdrive  (250-1046)    Addendum            Faxback Doc. # 3062

NOTE: The following changes and additions have been made to the Smartdrive
Manual.

1. All references to GJ1 (pages 4,5,6) will be J7 on your computer.

2. Step 2, page 4

The recording surfaces of the hard disk media are the product of
manufacturing process and are, therefore, not 100% perfect. Because of this,
a map is made of those areas that may not be usable and will be restricted
from use. This "media map" can be found on the top of the drive. Some drives
have no entries. Before installing the Smartdrive into your computer, step
2, page 4, take time to record the information from the "media map" in the
table provided there. Only the head and cylinder information is required.

3. Step 2 page 8

During Step 2, page 8, the Auto Install program will list the restricted
cylinders if any are present on the "media map" it will then display the
message "Do you wish to restrict cylinders from use (Y/N)?. If the list
displayed matches the "media error map" copied from the drive, answer "N"
followed by <ENTER>.

4. If the drive is partitioned, the second partition will be drive E.

5. On page 7 and 8 the reference to setuptl should be setuptl2.

(dkh-08/06/93)