52 MB SmartDrive (250-4124)        Addendum          Faxback Doc. # 3094

After you install the 52MB SmartDrive in your computer, you must run the
computer Setup utility to specify the drive type.  The drive type
information is listed in the following sections of the installation
guide:

Page 5, "Preparing the SmartDrive" in the "Before You Begin" section.

Page 22, "Initialization Instructions" in the "Completing the
                                               Installation" section.

Select Any (Non-Standard type) or Other as the drive type.  After you
select Non-Standard, enter the following information:

Cylinders           751
Heads               8
Landing Zone        750
Sectors             17

Entering the above information gives the drive a formatted capacity of
50MB or 51,988,480 bytes (1MB=1,048,576 bytes) as formatted under
MS-DOS 3.3.

If the Setup utility for your computer does not support the (Non-Standard
type) or Other option, select Type 12 as directed in the installation
guide.

This selection gives the drive a formatted capacity of 49MB or51,904,512
bytes (1MB=1,048,576 bytes) as formatted under MS-DOS 3.3.

Select "Y: for SmartDrive if the Setup utility for your computer has a
SmartDrive option.

NOTICE FOR NOVELL NETWARE USERS ONLY:

You must select drive type 12.  Novell does not support the Any
(Non-Standard type) or Other drive type at this time.

Jumper Pins:

There are three, not two, pairs of jumper pins at the rear of the drive.
Refer to the "Before You Begin" section in the drive installation guide
for an illustration of these pins.

(css 07/29/93)