AST 6033s/6066d  (250-0404)        Battery             Faxback Doc. # 3554

Replace the battery with a 3.0V battery only.  See your local Radio Shack
store for a replacement battery.  Use of a non-specified battery may
present a risk of fire or explosion.  See your local Radio Shack store
for battery replacement. The battery catalog number is 23-162 (CR2032).

Batteries may explode if mishandled.  Do not recharge, disassemble, heat
above 100 degrees Centigrade, incinerate, or expose contents to water.

Lithium batteries contain hazardous material and should be recycled.  In
some cases, it is illegal to dispose of these batteries as solid waste.

If the computer reports a CMOS or battery failure error, you may need to
replace the battery.  Run System Setup to check you configuration
settings.  If the settings are lost, the computer battery has run out and
needs to be replaced.

To replace the battery:

1.  Turn off the computer, unplug the power cord and disconnect any
    peripheral devices.  Remove the computer-chassis cover.

2.  Locate the battery (See Layout).

3.  Remove any add-in boards that prevent you from reaching the battery.

4.  Remove the lithium battery coin cell from the system board by lifting
    the battery straight up and out of the battery holder.

5.  Insert the new battery into the battery holder with the plus (+) side
    of the battery facing up. Press down firmly to seat the battery into
    the holder.

6.  Once the battery is in place, reinstall any add-in boards you removed.
    Replace the computer-chassis cover.  Reconnect peripheral devices and
    plug in the power cord. Turn on the system.

7.  Run System setup to configure the system.

(jjs/all-12/09/94)