JP 250 (26-2873)           Print Head Cleaning         Faxback Doc. # 4144


The printer's unique head cleaning system clears paper particles and dust
accumulated around the print head nozzles that may otherwise cause printing
problems. It also clears the nozzles and helps maintain a high level of 
print quality. However, if printing problems such as irregular dot print or 
dot missing should occur, clean the print head as described below:

 1. Make sure the printer is turned on and the paper is loaded.

 2. Make sure that the printer is online. Press an hold down the FWD ADJ 
    and REV ADJ switches.

 3. The ON Line indicator blinks for five seconds while the print head is
    being cleaned. The check pattern test can be printed by pressing the 
    LF/FF switch within three seconds after pressing the FWD ADJ and REV 
    ADJ switches. When the print check is completed, the printer returns to 
    normal online status.

Notes:

 ø Execute the head cleaning also when using a new Tandy Jet cartridge.
 ø To set the head cleaning mode properly, press the FWD ADJ and REV ADJ
   switches when the carriage is stationary.
 ø Do not execute unnecessary print head cleaning. Repeating the procedure
   excessively will waste ink.
 ø Even if the print check described in step (3) is executed, the data in 
   the buffer will be retained.
 ø The head cleaning can be also executed by turning the power switch on 
   while pressing the FWD ADJ and REV ADJ switches.


(jej 04/26/94)