DMP 203 (26-2880)        Using the Hex Dump Feature    Faxback Doc. # 4159


This feature lets you print the hexadecimal information the computer sends
to the printer. you can use this feature as a diagnostic tool when you have 
problems with the computer or the software.

Follow these steps to use the hex dump feature:

1. Load standard, 8.5-inch-wide paper.

CAUTION: The hex dump prints lines that are 8 inches long, so you must use 
         8.5-inch-wide paper to protect the platen.

2. While you hold down ON/OFF LINE, set the POWER switch to ON. When the
   ON/OFF LINE indicator lights, release ON/OFF LINE.
3. Send the print command from your computer.

Note: The last part of the computer file might remain in the printer's 
buffer. When the computer stops printing, press ON/OFF LINE so that the 
ON/OFF LINE indicator lights. This prints any information remaining in the
printer's buffer.

4. Set the POWER switch to OFF to end the hex dump mode.

(jej 04/25/94)