DMP 132  (260-2814)                Settings           Faxback Doc. # 4427

SW   SYMBOL         OFF        ON
1-1  Control Codes  Tandy      IBM
1-2  CR             CR=NL      CR=CR
1-3  LF             LF=LF      LF=NL
1-4  Form Length    11in.      12in
1-5  1 in Perf      Not Valid  
1-6  Line spacing   1/6in      1/8in
1-7  Character Gen  Tandy      IBM
     (IBM Mode)     IBMset1    IBMset2
1-8  WP/DP Mode     DP         WP
     (IBM Mode)     CR+LF      CR only
(2-1  Cancel Code   Valid      Not Valid
(2-2  Error Buzzer  NoSound    Sounds

TANDY Mode Only     2-1  2-2
Parallel            Off  Off
Serial 600          Off  On
Serial 1200         On   Off
Serial 2400         On   On

SETTING THE CHARACTER PITCH SET SWITCHES

You can set the character pitch of the DMP 132; however, note that once you
set the pitch by the front panel method, any control code sent from the
computer has no effect on the printing.  If you want to change the pitch
from the computer or your application software, do not set the pitch by
the front panel method.  The default CODE setting of pitch must be used.
Turning the power off and then back on restores the pitch to default CODE. 

To set the Character Pitch;

1. Be sure the ON LINE indicator is lighted.

2. Press and hold the PITCH (ON/OFF LINE) switch until the ON LINE indicator
   blinks.

3. Press the LINE FEED or FORM FEED switch to move the print head to the
   position indicated on the printer cover you wish to set as a character
   pitch.

4. Press the SET (NLQ/DP) switch to set the character pitch.

NOTE: When the CODE is selected, you can change the character pitch by
      sending control codes from the computer.

(jlc-01/11/93)