DWP 210  (260-1257)            Self-Test               Faxback Doc. # 4595

Perform the Self Test to insure that the Printer is operating properly, Do 
not perform the Self Test unless the Printer is loaded with wide (10") 
paper, since the Test prints the full width of the Platen. Printing direct-
ly on the Platen can shorten the life of the Print Wheel and the Platen. 
Self Test is performed in 600 baud mode only. Be sure you've set the DIP 
Switch No. 2 to CLOSE.

1. Turn the Power Switch ON.

2. Make sure that the Carriage returns to the left position.

3. Turn the Power Switch OFF.

4. Set DIP Switch No. 5 to CLOSE.

5. Turn the Power Switch ON. A Print Wheel index test is conducted
   automatically. (The Print Wheel turns clockwise ten times.)

6. Test printing follows and continues until the Power Switch is turned OFF.

7. Be sure to OPEN DIP Switch No. 5 after the test.

(dtc-07/27/93)