DWP 230  (260-2812)           Ribbon Replacement       Faxback Doc. # 4804

Fabric Cartridge (26-1458)

RIBBON CARTRIDGE INSTALLATION/REMOVAL

Radio Shack carries two ribbon cartridges for the DWP-230 -- a high-quality
carbon ribbon and a long life nylon ribbon. No matter which ribbon you 
choose, you'll find that they're both easy to install and remove.

NOTE: When the carbon ribbon runs out, the Printer detects the end of the
ribbon and stops printing. the nylon ribbon is an endless loop, so this 
will not happen.

TO INSTALL A RIBBON CARTRIDGE:

1. Before installing the cartridge, remove all slack in the ribbon by 
   turning the knob on top of the cartridge in the direction indicated by 
   the arrow (counterclockwise).

2. Position the cartridge so that the ribbon slides into position between 
   the print wheel and the card guide; the tabs on the cartridge should 
   line up with the green claws on the carriage.

3. Press down on the cartridge and snap it into place. (If necessary, turn 
   the ribbon feed knob 1/4 to 1/2 turn counterclockwise until the 
   cartridge locks down.)

TO REMOVE A RIBBON CARTRIDGE:

1. Gently press the green carriage claws away from the cartridge tabs.

2. Lift up on the cartridge. Be careful not to catch the ribbon on the 
   print wheel.

(dtc-07/27/93)