DWP 230  (260-2812)  Print Wheel Installation/Removal  Faxback Doc. # 4808

TO INSTALL THE PRINT WHEEL:

1. Remove the ribbon cartridge from the carriage as instructed in "Ribbon
   Cartridge Installation/Removal" section of this manual.

2. Grasp the carriage (near the platen) between your thumb and forefinger 
   and gently tilt the carriage toward you.

3. Grasp the print wheel hub by the center.

4. Position the alignment hole of the print wheel so that it corresponds 
   to and fits into the guide on the carriage.

5. Push down on the hub until the wheel fits snugly into place.

6. Grasp the carriage between your thumb and forefinger and gently tilt it
   away from you; firmly press the carriage down into its original position.
   (When the print wheel is properly installed, the hub will be toward the
   paper.)

7. Replace or reinstall the ribbon cartridge.

TO REMOVE THE PRINT WHEEL:

1. Remove the ribbon cartridge.

2. Tilt the carriage back as described above.

3. Grasp the print wheel hub and pull up. For easier removal, gently wiggle
   the wheel back and forth while pulling it up.

(dtc-07/27/93)