CM-2  (260-3212)                  Setup                Faxback Doc. # 4829

To set up the CM-2, you only have to connect the CM-2 to a compatible 
computer via cable.

Connecting to a Computer

To connect the CM-2 to a computer:

1. Make sure that power to all components is OFF.

2. Connect the RGB Cable to the RGB Connector located at the back of the
   monitor. Connect the other end of the RGB cable to the computer's RGB
   Interface.

After you have connected the CM-2 to a compatible computer, connect the 
CM-2's cord to the power source.

Using the CM-2

Power-up all equipment. Use your system owner's manual for instructions on
powering your computer and other peripherals.

After power-up, you may need to adjust the display on the CM-2.

Display Adjustment

The five display adjustment knobs are located below the video screen on the 
left side behind the control panel. The panel door swings downward when it 
is gently pulled forward at its left-most corner.

V-HOLD--This control stabilizes the display on the screen. Rotate the knob 
fully counterclockwise and then slowly clockwise until the display is 
stable.

V-SIZE--This control sets the vertical size.

H-CENT--This control horizontally centers the display area. Rotate the knob 
to adjust the position of the display.

CONT AND BRIGHT--Adjust the screen brightness to compensate for room light-
ing.

* If the room is dark, rotate either or both of these controls toward LOW
  until the picture is easily visible.

* If the room is bright, rotate either or both of these controls toward 
  HIGH until the picture is easily visible.

* The contrast (CONT) control also adjusts color brilliance, Low or High as
  required.

(dtc-07/27/93)