40 MB Internal Hard Drive  (250-4061A)  Settings       Faxback Doc. # 4981

* The 40 MB Hard Disk Drive is a half-height Winchester fixed-disk drive.

* The 40 MB Hard Disk Drive interface is compatible with the Seagate
  ST506/ST412 standard interface.

* Can operate at temperatures from 50 to 122`F with 8 to 80% non-condensing
  humidity.

* The standard Drive Select setting set at the factory configures the 40 MB
  Hard Disk Drive as the first (primary) disk drive. The standard Terminator
  setting configures the Hard Disk Drive as the terminal disk drive.

RODIME MODEL RO 3055 TYPE 92B  POSSIBLE PIN/SWITCH SETTINGS

Starting from the left, the first four pairs of pins are for drive selection.
Jumper one of these sets to configure the hard disk as Drive 1,2,3, or 4
(C,D,E, or F), respectively.

NOTE: The third and fourth sets of pins provide hardware support for a third
and fourth hard disk. The Hard Disk Controller board (25-4060 or 4058) for
your computer does not support more than two hard disk drives.

This drive includes a resistor for drive termination. Be sure the resistor 
is installed to configure the hard disk as the terminal drive. Otherwise, 
remove the resistor with tweezers or needle-nosed pliers.

(css 07/29/93)