TCS-100 Interface Board  (250-3021)  Settings          Faxback Doc. # 5178

There is a hardware modification for this board - I/O:108

The ANSI.SYS driver conflicts with the TCS Utilities, make sure ANSI.SYS is
NOT installed in the CONFIG.SYS file.

Default settings for the board are:
   DMA Channel = 1
   I/O Address = 338 Hex
   IRQ Used    = None

I/O Address (ADDR SEL)
Jumper B, D, E, G = 338-33B Hex (default configuration)
       B, C, E, H = 368-36B
       A, D, F, G = 398-39B
       A, C, F, H = 3C8-3CB

Interrupt (IRQ)
Default is no interrupt channel selected, you must chose one
2 - MSDOS (normal configuration)
3 - Xenix (normal configuration, hardware modification MUST be performed)
4
5
6
7

DMA     (DRQ)   (DACK)
MSDOS         1   1    (default configuration)
          2   2
Xenix         3   3

Extra Chip in kit is for 1000hd with Western Digital controller.  Chip
replaces BIOS on hard drive controller.

(smm/jej-05/12/94)