9600 BPS Faxmodem  (250-3029)        Installation      Faxback Doc. # 5221

INSTALLING THE FAX/MODEM BOARD IN YOUR COMPUTER

Before installing any board in your computer, you must disconnect all power 
and interface cables from the computer and move your computer to a 
static-free work area. Then, discharge any static buildup by touching a 
grounded metal object. Never power your computer when you have removed its 
case or when inserting or removing option boards.

This procedure involves removing the computer's case. If, after reading 
these instructions, you do not feel confident about your ability to install 
the modem, have a qualified service center install the modem for you.

Note: Service centers may charge for the installation of the modem.

To install your modem:

1.  Remove the screws that secure the computer's case and slide the cover 
    off to open the computer.  Save these screws.

2.  Select the expansion slot into which you want to install the modem. Your 
    modem card fits in either half- or full-card slots. Remove the slot 
    cover by removing its holding screw and lifting out the cover.

3.  Press the modem into the expansion slot.  Secure the modem using the 
    same screw you removed in step 2. Replace the computer case and secure 
    it with the same screws you removed in Step 1.

4.  Reconnect all interface cables for other peripherals.  Then, reconnect 
    your computer's power cable.

7.  Connect one end of the modular phone cable to a modular phone jack.

8.  Connect the other end of the modular phone cable to either of the modem's 
    two modular phone connectors.

You may also plug your phone into your fax/modem; that is the purpose of the
second jack on the back of the fax/modem. Your phone will operate normally, 
although you should avoid picking up the handset during either a fax 
transmission or modem connection as this will introduce errors into the 
transmission and may break connection.

(dtc-07/29/93)