Serial Mouse  (250-1040D)  Using the Serial Mouse      Faxback Doc. # 5334

After setting up the system and installing the mouse, you are ready to use
the mouse to control the cursor.  When using the mouse, be sure the buttons
are at the top of the unit, toward the monitor.

To move the cursor to the upper portion of the display, move the mouse away
from you.  To move the cursor sideways, move the mouse to the left or to the
right.

NOTE: The available movement area for the cursor is governed by the program
you are using.  Some programs allow you to use the entire screen area.  Other
programs restrict your movement to certain areas, of the screen.

You can also move the cursor diagonally.  And, if you are drawing graphics,
it is easy to move in a circular pattern with the mouse.

The two buttons at the top of the mouse can be used to make selections on the
screen.  Refer to the manual supplied with each application programs for
button functions.

CARE AND MAINTENANCE

* Do not drop the mouse.

* Be sure to place a mouse pad or a clean sheet of paper between the mouse
  and the flat surface. Dirt and grit can collect on the ball on the bottom
  of the mouse and mar the flat surface.

* Do not roll the mouse through any type of liquid.

To clean the ball, turn the mouse upside down. Put two fingers on the rigid
portions of the ball retainer and turn the retainer counterclockwise so that
the arrow points to the "O." Hold one hand over the mouse, turn it over, and
gently tap it. The ball and retainer drop into your hand.

Wipe the ball with a clean, soft, and dry lint-free cloth. Return the ball to
its housing an replace the cover. Lock the cover by turning it clockwise so
that the arrow points to the "C."

(css 07/30/93)