Plus Network 4 Board  (250-1019)  Settings             Faxback Doc. # 5393

Jumper location J1 selects the interrupt that is to be used. Be sure the jum-
per is set to interrupt 3 (IR3) as this interrupt is recognized by the soft-
ware.

This board uses I/O PORT address 248-24F Hex.

Dip switch SW 1 selects the station number.  The settings on the DIP switches
are a binary encoding of the numbers 0 to 63 (decimal).  Each switch repre-
sents a digit in the 6 bit binary number.  A switch set to down or OFF equals
bit ON or binary "1".  Switch SW 1-1 is the least significant bit.  The soft-
ware currently selects station 63 as the disk server, use 0-62 for work sta-
tions.

*NOTE: IRQ#3 is the same interrupt request as a COM 2 device.

(css 08/03/93)