Tecmar Captains Board  (250-3061)   Installation       Faxback Doc. # 5545

At this point in the installation procedure, your system cover should be off
and the system switches and Graphics Master jumpers should be set. You are now
ready to install the Graphics Master in your system. Follow the step by step
instructions below.

1. Choose the expansion slot for your Graphics Master. Remove the screw at the
   top of the slot and gently pull the slot cover upward.

2. Double check the jumper settings by turning back to the diagram for the
   setup you have chosen.

3. Locate the black plastic card edge guide that comes with your Graphics
   Master. Snap the card edge guide into the front of the computer opposite
   the slot you chose. The "fingers" in the channel on the card edge guide
   should be pointing down.

4. Position the board over the slot so that the gold fingers on the bottom of
   the board are directly over the slot connector on the bottom of the unit.

5. Hold the board by the top corners and press it firmly into the chosen slot.

   The black metal option retaining bracket (ORB) on the board should now be
   even with the rear panel of the unit, and the hole in the ORB should line
   up with the slot cover you removed.

6. Replace the screw you removed and use it to fasten the board firmly in the
   slot.

7. Replace the cover of your personal computer or Expansion Chassis.

8. Attach cables to boards, monitors, system unit, and electrical outlets as
   appropriate.

Your Graphics Master is now fully installed and ready for use.

(SMM/jlc-03/28/94)