Ethernet PLUS-16  (260-5507)         Install            Faxback Doc. # 5551
TP Adapter

  NOTE:  Always handle the adapter by its edges.

         Jumpers located at W1 and W2 are used to configure the
         Ethernet adapter.

CONFIGURATION JUMPER

A.   W1 is used to set the I/O base address, IRQ level, and RAM.
     
      Configuration Settings                 W1

       The soft jumper setting is used       W1
       to configure the adapter using        Soft            XX
       the setup program.                    280.3.D0000
                              300.10.CC000
       I/O Base Address = 240
     
                              W1
       I/O Base Address = 280      Soft
       IRQ = 3; Enabled            280.3.D0000     XX
       RAM Base Address D0000      300.10.CC000
 
                     Factory Default
     
                              W1
       I/O Base Address = 300      Soft
       IRQ = 10; Enabled                     280.3.D0000
       RAM Base Address = CC000		300.10.CC000    XX
     
B.   If neither of the two preconfigured settings is satisfactory
     (or if you are installing more than two adapters in the same
     computer), you MUST set the jumper to SOFT and run the soft-
     ware setup program to configure the adapter.

ROM JUMPER

A.   W2 should be set to NONE/SOFT if you are not using a ROM
     device.

B.   Only Boot ROMs v2.0 and later should be used with this
     adapter board.

C.   Correct installation

     1. Carefully insert ROM device into the ROM socket.  Avoid
        touching the pins and align the notch in the ROM device
        with the notch in the socket.

     2. Configure the ROM window size and base address.  Most
        ROM devices use 16K of address space.  Move the jumper
        at W2 to D8000.  This allows the ROM to respond to
        addresses in the range D8000 - DBFFF.  If that range is
        occupied, leave the W2 jumper at NONE/SOFT and use the
        software setup program to establish the ROM base at
        another location.  If it is necessary to change the
        window size from 16K to 32K or 64K, you must use the
        setup program.
     
     BOOT ROM OPTIONS              W2
                              1      2
     
     NONE/SOFT                XXXXXXXX
     D8000                         O      O
     
(SMM/jlc-03/28/94)