Deluxe Power Center  (260-0350) Operating Power Center Faxback Doc. # 5777

Some electronic devices draw a small amount of electrical power even when
the main power switch is turned off.  In order to prevent this small flow
of current from turning on the other five outlets, the sensitivity of the
AUTO SENSE outlet must be adjusted to a point ABOVE the small current
flow.

1.  Begin by setting the SENSITIVITY adjustment knob on the bottom of the
    unit to MAX by turning the knob fully clockwise with a screwdriver.

2.  Plug the power cord into a 120 VAC, 60 Hz outlet.  The green SURGE
    indicator lights.

3.  Plug the device to be monitored into the AUTO SENSE 240 W receptacle.

4.  With the power off on the monitored unit, plug a standard 60-watt
    lamp into any of the other receptacles.  If the lamp lights, turn the
    SENSITIVITY knob clockwise until the lamp turns off.  Turn the knob
    slightly more clockwise to prevent the Power Center from being turned
    on by power line disturbances.  The Power Center might hum until this
    adjustment is correct.  When the adjustment is correct, you can
    disconnect the lamp from the Power Center.

5.  Turn on the power switch of the monitored unit.  This automatically
    turns on the lamp or any other devices plugged into the other
    receptacles.

NOTE:  Additional adjustments in sensitivity might be required (as in
       step 4) if you plug a different device into the AUTO SENSE outlet.

(smc-02/09/94)