VGM-225  (25-4045)                  Setup              Faxback Doc. # 6004

Follow these steps to connect the monitor to your computer and to power.

1. Be sure that power to all components is off.

2. Connect the monitor's signal connector to the CPU of a compatible 
   computer.

3. Plug the monitor's power cord into the jack on the back panel. Then, 
   plug the power cord into a standard, grounded AC outlet or approved power
   strip.

4. Before you turn on the monitor, check your computer's owner's manual for 
   any instructions about turning on equipment connected to the computer.

5. Turn on the monitor.

NOTE: If horizontal lines appear on the screen, turn off the computer, be 
sure the signal connector is firmly connected, and turn on the computer.

Installing the Stand:

CAUTION: Before you install the stand, be sure the monitor's power cord is 
unplugged.

1. Turn the monitor upside down with the screen facing you.

2. Turn the stand upside down and place it on the monitor so that the word 
   FRONT is near the monitor's screen. (The letters will be upside down.)

3. Insert the eight stand-tabs into the eight slots on the bottom of the 
   monitor's chassis.

4. Push down the stand. Then, pull the stand toward you until it snaps into 
   place. Turn the monitor and the stand upright.

Setup Hints:

* Do not obstruct the ventilation opening.
* Install the monitor at least 4" away from the wall.
* Place the monitor on a flat, stable surface.
* Never block the openings on the bottom of the monitor by placing it on a
  bed, sofa, rug, or other soft surface.
* Place the monitor in a built-in enclosure only if proper ventilation is 
  provided.
* Never place the monitor near or over a radiator or heat register.
* Keep the monitor dry and free of excess dust. Moisture and dust can 
  damage the monitor.