TAD-248  (430-0757)          Remote Operation           Faxback Doc. # 6146

You can operate the TAD from almost any touch-tone phone or from a rotary
phone using a pocket tone-dialer available at your Radio Shack store.

You must enter the personal security code (marked on the back of the TAD)
before you can operate the TAD from a remote location.  This helps prevent unauthorized use of the TAD.

Remote Answer-On

You can activate the TAD while you are away from your home or office
provided:

*  AC power is on.

*  The cassette tape is installed.

Follow these steps to turn on the TAD from a remote location.

1.  Call your telephone number.  The TAD answers after about the tenth ring
    and sounds four beeps.

Note:  If the TAD answers after the second or fourth ring, the TAD is
       already set to answer calls.  You can either hang up or use its
       remote features.

2.  Enter your security code within eight seconds after the fourth beep.
    Hold the button down for at least two seconds for the TAD to recognize
    the code.  The TAD confirms the entry with a beep followed by your OGM.
    (If you do not enter the security code within 8 seconds, the TAD
    disconnects the call.)

3.  Hang up or use other remote features.

Other Remote Features

To operate the TAD from a remote location, do the following.

1.  Dial your phone number.  If there are recorded messages (including
    memos), the TAD answers on the second ring.  If there are no recorded
    messages, the TAD answers on the fourth ring.  A beep sounds and the
    OGM plays, followed by another beep.

Note:  If the TAD does not answer until after 10 rings, it is not set to
       answer calls.

2.  Press and hold your security code button for at least two seconds after
    the beep.  The TAD responds with a beep.

3.  After the beep, enter a remote command by pressing the appropriate
    number.  After each operation, the TAD beeps.  To end remote operation,
    hang up the phone.

Notes:

*  Unless you enter remote command 2 (Answer-Off) the TAD sets itself to
   answer calls after remote operation.

*  You must enter the remote command within 8 seconds after the beep.  If
   you do not, the TAD hangs up.

Use these commands to operate the TAD from a remote location.

*  Play-Press 3 after the beep to hear recorded incoming messages.  You
   hear various tones as the tape rewinds.  Then, the TAD plays the
   messages.  After the last message, two beep sound.  You can either save,
   erase, or replay the messages.

*  Change the OGM-Press 1 after the beep.  The TAD responds with two beeps.
   The TAD responds with two beeps.  Begin recording your new OGM.  When
   you finish, press 1 again to end recording.  A beep sounds and TAD
   plays back the new OGM.

*  Answer-Off-Press 2 after the beep to set the TAD not to answer incoming
   calls.  To set the TAD to Answer-Off after erasing messages, press 2
   again after the two beeps.

*  Save Messages-To save the messages, simply hang up the handset.

*  Erase Messages-Press 2 after play.  Two beeps sound, the TAD pauses,
   another beep sounds, and the TAD disconnects.  The tape rewinds and
   records future messages over the retrieved messages.

*  Replay Messages-Press 3 twice after playback.  The TAD responds with a
   beep, and replays the recorded messages.  You hear a series of tones as
   the tape rewinds.  After the last message plays, two beeps sound.  You
   can either save or erase the messages.

(RLR-02-24-94)