TAD-412  (430-0399)         Remote Operation            Faxback Doc. # 6150

When you dial numbers on a telephone away from your home or office, your
answering machine responds to your security-code numbers.

It also responds to the following remote-control commands:

[*] Activates remote
[1] Activates rewind
[2] Activates play

1.  Dial your phone number.  If the ANSWER switch is set at TOL S, and no
    new messages have been recorded since the last time you called, the
    answering machine waits four or five rings before it answers.  Then
    the outgoing message plays.

If the ANSWER switch is set at TOL S and it has received new messages, the
answering machine answers on the first or second ring, and the outgoing
announcement plays.

2.  While the outgoing-announcement is playing, press and hold [*] for
    about 2 seconds.  The outgoing-announcement pauses.

3.  Enter your 2-digit security code within 7 seconds after the
    announcement pauses.

If you enter an incorrect security code, the answering machine continues to
play the outgoing announcement.  Press [*] again and enter the correct
code.

If the code is correct and the answering machine has received a new
message, the incoming-message tape automatically rewinds to the beginning
of the new message (or block of messages).  Then the messages
automatically play back.

After playing the messages, your answering machine stops and sounds three
short beeps.  It waits 7 seconds for the next remote command.  Press [1] or
[2] if you want to review messages, (see "Reviewing Messages".)  If you
want to finish the remote control operation, hang up your telephone.
The answering machine automatically returns to the answer mode.  If your
answering machine does not receive any commands, after 7 seconds it hangs
up.  When you hang up, it also saves the messages and returns to the
answer mode.

Reviewing Messages

1.  Press [1] for rewind.  The incoming-message tape rewinds to the
    beginning of the most recently recorded message group.  While
    messages are rewinding, you hear intermittent beeps.  At the beginning
    of the new message group you hear three short beeps.

If you want to replay previously recorded messages, press [1] again.  The
messages rewind to the beginning of the tape, you will hear intermittent
beeps until the tape reaches the beginning of the tape.  Then all beeps
stop sounding.

2.  Press [2] for play.  The messages play.  At the end of the message
    group you hear three short beeps.  To listen to the second message
    group, press [2] again.

After the security code is entered and the answering machine is playing
the messages, if you hear three short beeps, you have reached the end of
a message group.  There is still space on the tape to record more new
messages.

*  If you hang up the telephone before the incoming messages have finished
   playing, the messages play to the end.  Then your answering machine
   returns to the answer mode.  None of the messages are lost.

*  If you do not need to save your messages, press [1] for rewind.  The
   answering machine rewinds the tape to the beginning of the new message
   group.  Do not press [2] for play.  This way the new messages will
   record over (and erase) the old messages.

*  When you press[1] for rewind, if you hear eight short beeps, you have
   reached the beginning of the tape.  IT cannot rewind further.  It is
   in position, however, to play back or to answer and record messages.

*  If your answering machine has received no new messages, it sounds three
   short beeps and waits 7 seconds for the next remote command.

(RLR-02-24-94)