TAD-450  (430-0720)          Remote Operation           Faxback Doc. # 6160

When you are away from your home or office, you can use a touch-tone phone
or pocket tone dialer to do any of the following:

*  Set the TAD to start or stop answering calls

*  Play your messages

*  Record a memo

*  Play your announcement or record a new announcement

*  Change the answering mode

Note:  If you plan to check your messages by long-distance, set ANSWER to
       TOL S to avoid unnecessary long-distance fees.

SETTING THE TAD TO ANSWER CALLS

If you set MASTER POWER to ON, and install both tapes before you leave your
home or office, you can later use any phone to set the TAD to answer calls.

To set the TAD to answer calls, dial the phone number and let the phone
ring until the TAD answers (about 1 1/2 minutes).  When the TAD answers,
hang up the phone.

Notes:
*  This sets the TAD to record messages.  To set the TAD to announce only,
   use remote command #.

*  If the incoming message tape is full, the TAD says "End of tape.  Enter
   remote code."  The TAD cannot record additional messages until you play
   all your new messages.

*  To prevent the TAD from being set to answer calls, set MASTER POWER to
   OFF.

USING REMOTE COMMANDS

To operate the TAD from a remote location, do the following:

1.  Dial the phone number.

2.  When the announcement begins, press *.  The TAD says, "Enter remote
    code."

3.  Enter your remote security code.  Be sure each key press is at least
    1/2 second long.

Note: If you do not correctly enter the code within 10 seconds, the TAD
      gives an error message.  After three errors, the TAD completes the
      announcement and records your calls as an incoming message.

4.  The TAD tells you the current call and message count, plays the new
    messages, and says, "Enter command or star for help."  Enter the
    command.  After each operation, the TAD says, "Enter command."

Note: If you do not enter a command within 10 seconds, the TAD hangs up.

1.    Rewind            Press to review the tape.  (You hear the Tape as it
                        rewinds).  The tape stops rewinding at the
                        beginning of the tape.

2.    Play              Press to play the incoming message tape, beginning
                        at its current position.

3.    Forward           Press to cue forward.  (You hear the tape as it
                        fast-forwards.)  The tape stops at the end of the
                        new messages.

4.    Record memo       Press to record a memo.  Begin recording after the
                        beep.  Press * to stop recording.

5.    Play              Press to play the announcement
      announcement

6.    Record            Press to record a new announcement.  Begin
      announcement      recording after the beep.  Press * to stop
                        recording.

7.    Beginning         Press to go to the beginning of the new message
      of messages       group.

8.    Monitor on        Press to monitor to the sound in the room where the
                        TAD is installed.  After 30 seconds, the TAD stops
                        monitoring.  To stop sooner, press *.

9.    End               Press to go to the end of the new message group.
      of messages

0.    Off               Press to set the TAD to not answer calls.

*     Stop/Help         Press to stop the current command.  Or, when the
                        TAD is not performing a command, press to play the
                        list of remote commands.

#     Change mode       Press to change the answering mode.

(RLR-02-25-94)