TAD-510  (430-0750)          Problem Solving          Faxback Doc. # 6320

Refer to the following problem-solving information to find possible
causes and remedies for various problems with the TAD.

The TAD does not        There is a bad power connection.  Check the AC
answer.                 adapter and reconnect it, if necessary.

                        There is a bad phone line connection.  Check the
                        telephone cord and reconnect it, if necessary.

                        The TAD is not in the answer mode.  Press ANSWER
                        so the ANSWER indicator lights.

                        The outgoing announcement cassette is not
                        installed.  Install the cassette.

                        The incoming message tape is full.  Play the new
                        messages.  Then rewind the tape to the beginning
                        of the new messages or to the beginning of the
                        tape.

The TAD does not        The incoming message cassette is not installed.
record messages.        Install the cassette.

The outgoing            There was a pause of more than 2 seconds in the
announcement tape       outgoing announcement, or the outgoing
stops in the middle.    announcement tape reached the end while you
                        recorded the announcement.  Re-record the
                        announcement.

The recorded sound      Outgoing Announcement-You were too close to
is distorted.           the microphone or spoke too loudly.  Re-record
                        the announcement and speak in a normal voice
                        about 12 inches away from the microphone.

                        Outgoing Announcement and Incoming Message-
                        The tape heads are dirty.  Clean the heads using
                        an audio tape head cleaning kit (available at
                        your local Radio Shack store).

                        The tape is worn out.  Replace the cassette.

(LB/smc-05/05/94)