TAD-276 (430-0762) Troubleshooting Faxback Doc. # 6374 We do not expect you to have any problems with your TAD, but if you do, be sure you installed the MC-20 and MC-60 cassette tapes and set STOP/ON to ON. If you still have a problem, this chart might help. If not take the TAD to your local Radio Shack store for assistance. PROBLEM CAUSE SOLUTION The TAD won't answer Bad phone line connection. Check and reconnect. and record caller's messages. The first outgoing Record an outgoing announcement is not announcement. recorded on the MC-20 tape. The STOP/ON switch Set the switch is set to STOP. ON. The TAD records a The caller hung up If this happens dial tone, beeping without leaving a often, discuss or the operator's message or without the problem voice instead of using the maximum with the caller of the callers message length, and and/or your message. your phone company phone company does not send out CPC signals. The TAD sounds two The MC-60 tape is Use remote operation beeps and hangs up full and you have not to play all your when you call. recorded a second recorded messages announcement. so the TAD resets to record new ones. Recordings sound You were to close to Re-record and distorted. the microphone or you speak 12-inches spoke too loudly when from the microphone you recorded the out- in a normal voice. going announcement/ memo recording. The tape heads are Clean the heads dirty. using a tape head cleaning kit. The tapes are worn Replace the tapes, out. We recommend you replace the tapes at least once a year. The remote control You are using a pulse Use a touch-tone functions do not dialing phone. phone or pocket work. tone dialer. The tone output from Try using another the phone or tone dialer phone or dialer. is not long enough. The telephone line might Enter the remote be noisy. code again to call the TAD. The security code was Re-enter the not correct. correct code. 7 seconds have passed Call the TAD and and the TAD has hung try again. up. Continuous beeps A cassette tape is Replace the tape. sound and Er appears jammed or broken. on the display The TAD does not The TAD is locked up. Unplug the adapter respond to any from the AC button. outlet and then plug it in again. STOP/ON is set The TAD has been turned Set STOP/ON to ON to STOP, but the on remotely. and then to STOP TAD continues to again record messages. (CJD/smc-05/11/94)