HS-229  (430-0182)           Preparation              Faxback Doc. # 6477

INSTALLING/REPLACING THE BATTERY

The headset amplifier requires one 9 volt rectangular battery (not
supplied) for operation.  For the longest operation and best performance,
use an alkaline battery (Radio Shack Cat. No. 23-553).

1.  Remove the headset amplifier from the phone, then remove the battery
    compartment cover by sliding it in the direction of the arrow.

2.  Remove the old battery (if any) from the battery compartment, then
    unsnap it from the battery connector.

3.  Snap a new battery onto the battery connector.

4.  Place the new battery and battery connector in the battery
    compartment.

5.  Replace the battery compartment cover and reattach the headset
    amplifier to the phone.

CONNECTING THE HEADSET TO THE PHONE

1.  Unplug the phone's modular handset cord from the handset jack on
    the phone's base.

2.  Plug the phone's modular handset cord into the HANDSET jack on the
    right side of the headset amplifier.

3.  Plug the telephone modular coiled cord from the right side of the
    headset amplifier into the handset jack on your phone's base.

4.  Plug the headset's modular connecting cord into the HEADSET jack on
    the left side of the headset amplifier.

ADJUSTING THE HEADSET'S SPEAKER

You can wear the headset on either ear.  Wear the black earpad next to
the ear you choose.  Depending on which side you choose, you might have
to adjust the headset's speaker so the black earpad is next to your ear.

1.  Hold the headset in either hand next to the speaker. 

2.  Grasp the speaker between the thumb and index finger of your free
    hand, then gently twist the speaker as far as it will go.

Cautions:  The speaker should twist easily.  If it does not, do not force it.
           Try to twist it in the opposite direction.

           The speaker turns 180 degrees and the speaker/microphone assembly
           turns 60 degrees.  Do not try to turn either beyond this limit.

(CJD/smc-05/16/94)