Range Doubler Multitester  (220-0215)   Features       Faxback Doc. # 6536

The Radio Shack Range Doubler Multitester is a high-sensitivity analog
multitester, ideally suited for field, lab, shop and home applications.
These features make the multitester easy to use and ensure accurate and
reliable operation.

                Range Doubler Switch - effectively doubles the number of
                                       available AC and DC scales for
                                       greater accuracy.

Low DC Ranges - 125 mV and 25 microA - great for solid state work.

 Sensitive 18 microA- Meter Movement - simplifies accurate reading
                                       with 4 1/2-Inch Face and Mirrored
                                       Scale

            Built-In Diodes and Fuse - protect meter movement and other
                                       internal parts in case of improper
                                       function selection.

         Audible Continuity Function - built-in buzzer sounds when there
                                       is continuity.

                     Carrying Handle - can be flipped to the back to
                                       support the meter at an easy-to-
                                       read angle.

Note:  You need one 9-volt and one 1.5-volt AA battery (not included) to
       operate this multitester.

Warning:  USE EXTREME CAUTION IN THE USE OF THIS DEVICE.  IMPROPER USE OF
          THIS DEVICE CAN RESULT IN INJURY OR DEATH.  FOLLOW ALL
          SAFEGUARDS SUGGESTED IN THIS OWNER'S MANUAL IN ADDITION TO
          NORMAL SAFETY PRECAUTIONS IN DEALING WITH ELECTRICAL CIRCUITS.
          DO NOT USE THIS DEVICE IF YOU ARE UNFAMILIAR WITH ELECTRICAL
          CIRCUITS AND TESTING PROCEDURES. NOT FOR COMMERCIAL OR
          INDUSTRIAL USE.

A WORD ABOUT SAFETY

We have taken every precaution in designing and manufacturing this meter
to ensure that it is as safe as we can make it.  But safe operation
depends on you, the operator.  We recommend that you follow these simple
safety rules.

  Use extreme caution when working with voltages above 30 Volts AC or 60
  Volts DC.  Always disconnect power from the circuit you are measuring
  before you connect the test probes to high-voltage points.

  Never connect the test probes to a source of voltage when you select
  resistance, continuity, or current measurement functions.  Always turn
  off the meter's power and disconnect the test probes before you replace
  the batteries or fuse.

  Never operate the meter unless the back cover is in place and fully
  closed.  Because some AC/DC sets have a hot chassis, be sure that the
  top of your work bench and the floor underneath it are made of non-
  conductive materials.

  The meter is fully calibrated and tested.  Under normal use, no further
  adjustment should be necessary.  If the meter should require repair, do
  not try to adjust it yourself.  Take it to your local Radio Shack store.
  Service by unauthorized personnel voids the warranty.

(BR/all-07/11/94)