Rock Runner/Car Crusher (600-4133) Operation Faxback Doc. # 6598 Warning: Never operate your vehicle in the street. 1. Fully extend the transmitter's antenna. For maximum range, hold the transmitter with the antenna pointing straight up. 2. Set the transmitter's ON/OFF switch to ON. 3. Set the vehicle's ON/OFF switch to ON. 4. Operate the vehicle using the speed and steering controls. Push the speed control away from you to make the vehicle go forward. The farther you push, the faster the vehicle goes. Pull the control toward you to make the vehicle go in reverse. The farther you pull, the faster the vehicle goes. Release the control to stop the vehicle. Move the steering control left to make the vehicle turn left, and move it right to make the vehicle turn right. The farther you push, the sharper it turns. Release the control to make the vehicle go straight. 5. Set the vehicle's ON/OFF switch to OFF. 6. Set the transmitter's ON/OFF switch to OFF. Cautions: Do not touch the motor immediately after using the vehicle, as it may become hot during use. To protect the motor, wait until it cools before using another battery pack to run it. The nylon nuts on the rear wheels might become loose after a long period of use. If this happens, set the vehicle's ON/OFF switch to OFF and tighten the nuts with the supplied box wrench. RACING TWO OR MORE CARS Your vehicle and other radio-controlled cars use specific control frequencies to operate. Cars with different frequencies can race each other without interference. Cars with the same frequency cannot. The following chart shows the control frequencies available for this vehicle. If you buy more than one, be sure the colors of the ribbon on the transmitter antennas are different to ensure that they use different frequencies. Band Transmitter Receiver Ribbon Color 2 27.045 MHz 26.590 MHz Red 4 27.145 MHz 26.690 MHz Yellow 6 27.255 MHz 26.800 MHz Blue (LB/all-08/17/94)