PIR Alarm  (490-0320A)          Operation               Faxback Doc. # 6619

TURNING ON THE ALARM

After you test the covered area and position the alarm as desired, set
ALARM to ARM to turn on the alarm.

After a 20-second exit delay, the alarm can detect intruders.

SOUNDING THE ALARM

If someone enters the protected area after the exit delay, the alarm
sounds instantly if ENTRY DELAY is set to INST or 15 seconds after the
sensor detects motion if ENTRY DELAY is set to DELAY.

Note:  When ENTRY DELAY is set to DELAY, the alarm sounds after the delay
       even if the intruder has left the covered area.

The alarm sounds for about 5 minutes (unless you turn off the alarm).
Then, the alarm does one of the following:

*  If the sensor does not detect someone at the end of the 5 minutes, the
   alarm resets and is ready to sound again in case of another intrusion.

*  If the sensor still detects an intruder after the 5-minute alarm, the
   alarm sounds again for 5 minutes.  It sounds instantly if ENTRY DELAY
   is set to INST or after 15 seconds if ENTRY DELAY is set to DELAY.

TURNING OFF THE ALARM

To turn off the alarm, set ALARM to OFF or use the remote switch (if you
installed one).

(br/all-6/27/94)