Wired Intercom  (430-0223A)       Installation         Faxback Doc. # 6705

1.  Choose the most convenient location for the master unit and for each
    remote station.

2.  Connect a cable from each remote station to the corresponding jack
    on the rear of the master station.

NOTES:  Be sure to route the cables so that they are not pinched by doors
        or stepped on.

        To Install the stations more than 66 ft. apart, you can make a 
        connecting cable of 22 gauge wire (radio Shack Cat. No. 278-1385)
        and two 1/8" two-conductor plugs (Radio Shack Cat. Not. 274-286).

INSTALLING THE BATTERY

1.  Open the master station's case by inserting a coin into the slot
    between the top and bottom of the case and twisting the coin.

2.  Snap the battery connector over the terminals of a 9-volt battery,
    following the correct polarity.

    We recommend a Radio Shack alkaline battery (Cat. No. 23-553).

3.  Place the battery inside the case.

4.  Replace the cover and snap the case together.

NOTE:  You can use a Radio Shack AC adapter (Cat. No. 273-1431) in place
       of a battery.

(CJD/all-8/17/94)