2 X 50 Watt Truck Amp  (120-1971)      Connecting       Faxback Doc. # 6715

You can connect your stereo system to low-or high-level input.  If your
stereo system has RCA outputs, connect it to the amp's low-level input for
a cleaner, less noisy signal.  If your stereo system only has speaker
outputs, connect it to the amp's high-level input.

To connect the amplifier to your stereo system,  place the amplifier as
close as possible to the selected mounting location and follow the
appropriate instructions.

LOW-LEVEL INPUT

Your amplifier has gold plated color RCA terminals for low-level input to
match radios and equalizers with RCA type, line-level outputs.

  NOTE:  You need a set of 12-foot RCA cables for dash to trunk
         mounting.  We recommend Radio Shack Cat. No. 43-2356.

Follow these steps to connect the stereo system's RCA jacks to the
amplifier's LOW INPUT terminals:

1.  Plug the RCA cable into the car stereo system's left and right RCA
    output jacks and connect the other end to the amplifier's left and
    right LOW INPUT terminals.

2.  Connect the left speaker's positive (+) wire to the amplifier's 
    positive (+) left terminal.

3.  Connect the left speaker's negative (-) wire to the amplifier's
    negative (-) left terminal.


4.  Repeat Steps 3 and 4 to connect the right speaker to the amplifier's 
    right speaker terminal.

    NOTE:  We recommend 16 or 18 gauge speaker wire.


HIGH-LEVEL INPUT

If your car radio does not have RCA output jacks, connect the speaker
output from the stereo system to the amplifier following these steps:

1.  Connect the stereo system's speaker wires to the amplifier's
    HIGH INPUT L and R terminals.

    NOTE:  Be sure you connect the + and - terminal correctly.

2.  If the stereo system has only three wires, connect the common
    speaker wires to both of the amplifier's L and R negative terminals.

3.  Connect the left speaker's positive (+) wire to the amplifier's
    (+) left terminal.

4.  Connect the left speaker's negative (-) wire to the amplifier's 
    (-) left terminal.

5.  Repeat Steps 3 and 4 to connect the right speaker to the amplifier's
    right speaker terminal.

(CJD/all-06/29/94)