Mini Stereo  (130-1270)           Installation          Faxback Doc. # 6738
Component System

NOTES:  Properly make all connections as shown before you plug in and turn
        on the system.

        We recommend you place a cloth or other protective material under
        the system and the speakers when you place them on a desk or table
        top with a natural oil or lacquer finish.

1.  Connect the dipole antenna and fully extend it.

2.  Plug the left speaker's wire into the SPEAKER L jack on the system.
    Plug the right speaker's wire into the SPEAKER R jack.

    SPEAKER PLACEMENT:  For the best stereo separation, place the speakers
                        5 - 10 feet apart, facing your listening position
                        and as close to ear level as possible.

3.  Connect optional equipment to the CD/AUX L and R jacks.

4.  Plug the system's AC power cord into a 110-120 VAC wall outlet.

5.  Plug the AC power cords of any optional equipment into an appropriate
    power outlet.

NOTE:  Save the original packing material your unit came in.  These
       materials provide the best protection for the system when it is
       moved or should it become necessary to return it for service.


OPERATING THE REMOTE CONTROL

The remote control lets you turn the system on and off, adjust the
volume, or mute the sound from virtually anywhere in the room.  It also
controls the CD player's skip, play/pause, and stop function.

Installing Batteries

The remote control is powered by two AAA batteries (not included).  Insert
the batteries as shown, making sure polarity is as shown inside the
compartment, (+ to + and - to -).  For the best operation and longest
life, we recommend you use alkaline batteries, such as Radio Shack Cat.
No. 23-555.  Replace the batteries when operation becomes erratic or after
about one year to ensure continued good performance.


USING THE REMOTE CONTROL UNIT

NOTE:  The remote control uses an infrared beam which is not affected by 
       noise or other interference.  It is affected, however, by strong
       light, so do not allow strong sunlight to fall on the receiver's
       front panel.

1.  Point the remote control at the system's remote sensor.

2.  POWER ON/OFF - Press to turn on the system.  Press again to turn off
    the system.

3.  VOLUME UP/VOLUME DOWN - Press Volume Up or Volume Down, as desired. 
    The volume level changes in steps each time you press the button.
    Press and hold down for continuous change.

4.  Mute - Press to mute the sound.  The Mute indicator lights.  Press 
    again to restore the volume level.

5.  Skip >>/ Skip /<< - Press and release to skip to the next higher or
    lower track on a CD.  Press and hold down to quickly scan forward
    or backward within a track.

NOTE:  If the CD is playing, it returns to the beginning of the current 
       track.

6.  Stop (BLACKENED SQUARE) - Press to stop the CD player.

7.  Play/Pause (>/||) - Press to start the CD player.  Press during play
    mode to pause a CD.  Press again to resume playing the CD.

(CJD/all-06/29/94)