Hi-Pwr Digital Cassette (120-1994) Installing/Removing  Faxback Doc. # 6937

ROUTING SPEAKER WIRE

If you install speakers, avoid routing the speaker wires near moving parts
or sharp edges.  You can usually route them along the wiring channel
beneath the vehicle door's step plates by carefully removing the molding
that holds the carpet in place.  After you route the speaker wires,
replace the molding.

MOUNTING THE STEREO

If your vehicle does not have a prepared opening for a flat face (DIN E)
component, you must use an in-dash installation kit.  Installation kits
for many vehicle models are available at your local Radio Shack store.

If you require an in-dash installation kit, follow the instructions
supplied with it to mount the sleeve.

If you are not using an in-dash installation kit, follow these steps to
mount the stereo.

1.  Disconnect the cable from the vehicle battery's negative (-) terminal.

2.  Temporarily disconnect the wiring harness and antenna.

3.  Insert the sleeve into the dash opening.  Secure the mounting sleeve
    by bending the locking tabs outward with a screwdriver.

4.  Route the wiring harness and the antenna wire through the sleeve from
    under the dash.

5.  Reconnect the wiring harness and antenna.

6.  Slide the stereo into the sleeve until it locks into place.

Note:  To further secure the stereo, attach the supplied hex bolt to the
       back of the stereo.  Attach one end of the supplied metal strap to
       the bolt on the back of the stereo.  Attach the other end of the
       strap to an existing bolt on a solid metal part of the vehicle.
       This strap also helps ensure proper electrical grounding of the
       stereo.

7.  Reconnect your vehicle battery's negative cable.

REMOVING THE STEREO

Follow these steps to remove the stereo from the dash.

1.  Disconnect the negative (-) cable from your vehicle's battery.

2.  If you used the metal strap, release it.

3.  Push the sleeve keys into the slots on the right and left of the
    front panel until you hear a click.

4.  Pull the keys out and down to remove the stereo.

5.  Disconnect the wiring harness and the antenna cable.

6.  Remove the stereo from the mounting sleeve.

7.  Reconnect the battery's negative (-) cable.


(smm 03/04/94)