FM Wireless Microphone  (320-1221)   Installation       Faxback Doc. # 7046

1.  Clip the microphone at the desired location.  Three to six inches from
    your mouth is best.

2.  Clip the transmitter unit to your belt or pocket.

3.  Turn the receiver POWER switch on.  The POWER indicator lights.

4.  Fully extend the telescoping antenna of the receiver.

5.  Set the transmitter's OFF-STAND-BY TALK switch to TALK.  The READY
    indicator lights.

6.  Speak into the microphone and adjust the VOLUME control on the
    receiver and/or  your amplifier to the desired level.

STANDBY OPERATION

If you want to turn off the microphone without turning off the
transmitter, set the transmitter's OFF-STANDBY-TALK switch to STANDBY.
The READY indicator remains on.

When you are ready to talk again, move the switch to TALK.

The standby mode lets you control the microphone, but avoid the popping
noise that might occur if you move the switch to OFF and back to TALK.

When you finish talking, be sure to move the switch to OFF to conserve
battery power.

CHANNELS OF OPERATION

The wireless microphone system is available in two different frequencies
49.830MHz or 49.890MHz.  This lets you use two units with different
frequencies at the same time/place if necessary.

However, do not attempt to use more than one microphone/transmitter unit
with each receiver.

(smc-02/24/94)