TRC-508  (210-0408)               Installation         Faxback Doc. # 7078

ATTACHING THE BELT CLIP

Each TRC-508 comes with a belt clip. To install the clip, simply slide it
into the slot on the back of the transceiver until it locks into place.

To remove the clip, lift up one the locking tab and slide the clip out.

CONNECTING THE EARPHONE/MICROPHONE

The TRC-508 transceivers come with 4 rubber tips for each earphone/
microphone.  Select the tip that most comfortably fits you ear and slide
it onto the earphone/microphone.  Then connect the earphone/microphone to
the two prongs on the TRC-508's cord.

NOTE:  The prongs are different sizes and only fit the cord one way.
       Do NOT try to force the connection.

1.  Put on the earphone/microphone.

2.  Set the main switch to either PTT (for manual push-to-talk
    communication) or VOX (for hands-free operation).

3.  Set VOLUME HIGH/MID/LOW to the most comfortable listening level.

4.  If you set the main switch to VOX operation, set VOX HIGH/MID/LOW for
    operation as follows:

-In a noisy environment, set VOX HIGH/MID/LOW to LOW.  This prevents
 background noise from keeping the transceiver in the transmit mode.
 With this setting, you must speak louder to make the transceiver
 transmit.

-In a quieter area, set VOX HIGH/MID LOW to HIGH or MID.  At these
 settings, you do not have to speak as loudly to automatically switch to
 transmit.

5.  If the main switch to PTT, press PUSH TO TALK to transmit.  Release
    PUSH TO TALK to receive.

6.  Set the main switch to OFF to turn off the transceiver.

The TX/BUSY indicator lights green when the TRC-508 is receiving a message
and red when it is sending a message.  It is off when the transceiver is
neither sending nor receiving.

The TRC-508 cannot receive while transmitting.  Wait for the other person
to stop talking before transmitting.

(smc-02/25/94)