Wireless Infrared  (150-1959)         Installation     Faxback Doc. # 7081
Remote Control Extender

The Radio Shack Wireless Infrared Remote Control Extender includes a
transmitter and a receiver.  The transmitter senses the infrared signals
from your audio/video equipments remote controls and converts them back to
identical infrared signals, then relays them to the audio/video equipment.

INSTALLING THE RECEIVER

Follow these steps to install the receiver.

1.  Place the receiver in front of the audio/video equipment and position
    it as follows:

    A:  Within 20 feet of the audio/video equipments remote sensor.

    B:  With the receivers front directly in front of the audio/video
        equipments remote sensor.

2.  Fully extend the telescopic antenna.

NOTE:  The extender system's LEDs (particularly the transmitter's) might
       blink occasionally.  This is caused by interference in the local
       vicinity and is normal.

(smc-02/28/94)