AM/FM Stereo Headset  (120-0105)      Operation        Faxback Doc. # 7087
With Digital Tuning

PLAYING THE HEADSET

1.  Press and hold down POWER until the band and station appears on the
    display.

2.  Press BAND to select AM or FM.

3.  Press TUNING (up arrow) or (down arrow) for 1 second to quickly scan
    the station.  When you release it, the headset automatically tunes to
    the next strong station.

4.  Adjust VOLUME to a comfortable level.

5.  Press POWER to turn off the headset.  If you do not turn off the
    headset, it goes off automatically in 60 minutes to save battery
    power.  To continue listening, press and hold down POWER until the
    band and station appear on the display.

TRAFFIC SAFETY

Do not wear the headset while operating a motor vehicle or riding a
bicycle.  This can cause a traffic hazard and is illegal in some
areas.

Do not wear the headset while walking in areas near bicycle or motor
vehicle traffic.

ADJUSTING THE HEADSET

The headband can be adjusted for a custom fit.

Firmly grasp the headband's center section and slide each side in or out
to obtain the proper fit.

MEMORY TUNING

Store favorite stations into memory so it can easily turn to them or scan
to them.  Up to 20 stations (10 stations in each band).

STORING A STATION IN MEMORY

1.  Press POWER.  Then select the band and station desired to be stored
    into memory.

2.  Press MEMORY.  1 appears and MEMORY flashes on the display for about
    10 seconds.

3.  While MEMORY flashes, repeatedly press M-SELECT until the display
    shows the memory location number wanted to assign to this station.

4.  Press MEMORY again.

5.  Select the band and station wanted to store into memory and repeat
    steps 2-4.

NOTES:

A.  If the steps are not completed within 10 seconds, MEMORY disappears,
    and the headset does not store the station in memory.  Then one must
    begin again at Step 2.

B.  If a location number is assigned previously , the new station replaces
    the old one.

TUNING TO A PROGRAMMED STATION

To tune to a programmed station, select the appropriate band and
repeatedly press M-SELECT until the desired memory location number appears
on the display.  To move quickly through the memory locations, press and
hold M-SELECT.

LOCKING THE CONTROLS

LOCK IN/OUT prevents accidentally turning the headset on for off, changing
the band or station, or changing other controls.  The VOLUME can still be
adjusted.

To lock the controls, set LOCK IN/OUT to IN.  LOCK appears on the display.
To unlock the controls, set LOCK IN/OUT to OUT -O LOCK disappears from the
display.

NOTE:  Automatic power-off works even when LOCK IN/OUT is set to IN.

(smc-02/28/94)